3 - Stages mechanism loader for lead-acid batteries 12V 2,5A
inclusive battery connecting terminals and quadrilingually guidance
The load principle
Contrary to battery chargers with U/I - characteristic, takes place with these
equipment the charge with constant current. Thus the charge takes place substantially
faster, because the Batteries are loaded up to the load end with the maximum
current. In addition the accumulators are loaded to 100 %. Controlled gassing
is desired thereby since it extends a forming of sulfate layers substantially
affected and thus
the accumulator life.
Up to a tension of 14,7 V the accumulator willl be loaded
with the max. current. Afterwards the equipment changes 1 hr. in the timer
mode and the battery with constantly
sinking current is loaded. After approx.. 1 hr. changes the equipment in the
stand-by-mode and the preservation charge with 13,8 V is automatically introduced.
This clarifies following graphics. Also to the loading suitably by lead gel
batteries.
Security
If the accumulator is attached inadvertently wrongly polarized to the
battery charger, then the charging current is switched off. Of course
the devices are short-circuit and polarity safe. Three LED's
indicate the respective charge.
Technical Data
| . |
details |
| type |
12V
2,5A |
| Operating voltage: |
230V
~ 50Hz |
| Charging current: |
max.
2,5A |
| Accumulator tension: |
12V |
| Load conclusion tension: |
12V-Akkus:
14,7 V |
| conservation charging |
12V-Akkus:
13,8V |
|
